- #Digitech rpx400 usb drivers windows 10 x64 install
- #Digitech rpx400 usb drivers windows 10 x64 pro
- #Digitech rpx400 usb drivers windows 10 x64 software
#Digitech rpx400 usb drivers windows 10 x64 software
Put the X-Edit software CD into your CD-ROM drive. however, installation of the software IS NOT complete. When the message "Your new hardware is installed and ready to use" appears,windows has completed identifying your new hardware. Wait until Windows has found and identified all of the USB devices from the RPx400.
There are multiple messages because there are four USB devices in the RPx400, two MIDI devices and two audio devices. Connect the included USB cable to your computer and to the RPx You will see multiple messages pop up from the task bar indicating that your computer has found a new USB device. Remove the USB Warning sticker covering the RPx400 s USB port. Take the RPx400 out of the box and plug the power in. Follow the directions in the section that applies to your operating system. There are different installation procedures for Windows XP users and Windows 2000 users.
#Digitech rpx400 usb drivers windows 10 x64 install
Installing DigiTech USB Drivers You must install the USB drivers to use the RPx400 s USB connection with your computer.
#Digitech rpx400 usb drivers windows 10 x64 pro
Click Exit from Pro Tracks Installation screen.
When the Installation Complete window appears deselect Launch Pro Tracks and Read Me check boxes and click Finish. Click Install Pro Tracks to start installation again. NOTE: If you exit Setup without completing the installation, choose Start>Run, type d:\autorun.exe (where d:\ is your CD-ROM drive), and click OK. If DirectX is installed at this time, you will need to restart your computer and return to Step 1. If DirectX 8.1+ is not installed, the installer will automatically install it for you. Click the Install Pro Tracks button and follow the installation instructions on the screen. If the menu does not appear automatically, you can open it by selecting Start>Run and entering d:\autorun.exe (where d:\ is the letter of your CD-ROM drive). If you have autorun enabled, the Pro Tracks installation menu opens automatically, showing you several buttons. Place the Pro Tracks CD-ROM in your CD-ROM drive. Close any open programs you have running.
Please follow these instructions carefully to ensure smooth installation of each of these components. This installation guide contains the information to install the required USB drivers, X-Edit editor/librarian and Pro Tracks recording software for use with the RPx400. 1 RPx400 USB Drivers and Software Installation GuideĢ Congratulations on your purchase of a DigiTech RPx400.
0 kommentar(er)
